A-A-30085E
Quality Assurance Provisions.
Responsibility for inspection. Unless otherwise specified in the contract or purchase order) the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract or purchase orders the contractor may use his own or any facilities suitable for the performance of the inspection requirements specified herein; unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
Records. Records of examinations and tests performed by or for the contractor shall be maintained by the contractor and made available to the Government upon the Government’s a request, at any time, or from time to time, during the performance of the contract and for a period of three years after delivery of the supplies to which such records relate.
Inspection. Inspection as used herein, is defined as both examination (such as visual or auditory investigation without the use of special laboratory appliances or procedures) and testing (determination by technical means of physical and chemical properties) of the item.
Tests. Tests shall be conducted to determine compliance with this commercial item description requirements. Where feasible, the same sample shall be used for the determination of two or more test characteristics.
Leakage test. The cap shall have a leakproof seal when tested as follows: The cup is to be filled with 4 oz. (118 mL) of water. With the cap placed firmly on the cup, the cup will be held upside down and then placed on its side on a flat surface for 5 minutes. Any evidence of leakage will constitute failure.
Sampling for examination. Sampling for examination shall conducted with MIL-STD-105, with an AQL of 1.0 (percent defective) and an inspection level of S-1.
Sampling for tests. Tests shall be conducted to determine compliance with specification requirements. Where feasible, the same sample shall be used for the determination of two or more test characteristics.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business